Decide where to place your water tank

Follow these simple steps

• Select a smooth, firm, level surface on which to site the water tank (paving, concrete and sand are all suitable).

• When selecting a site to place your water tank also give consideration to maximising the best possible position to capture water from your roof area

• Ensure the roof, gutters and downpipes in the catchment area are clean and free from depressions that may hold leaves, dirt or stale water. There are a number of accessories such leaf strainers and water diverters that assist in this area. (See accessories).

• The downpipe from the gutter must be on a gradual (3% or greater) slope to the inlet which is the leafstrainer on the roof of the water tank.

• Additional piping can be connected to the overflow to direct excess water away from the water tank or alternatively install the inlet pipe so that it can shut-off when the tank is full.

• For the urban range of water tanks, a handyman or DIY person can easily set - up the tank. If you would like the tank installed ring your local plumber or contact us at West Coast Poly and we can supply names of installers that are familiar with our products.

Maintenance

The following steps are simple guidelines to maintaining a clean and fresh fill of rainwater.

• Allow the first rains to flush clean the roof area and downpipes before directing water into your water tank.

• At regular intervals, check to ensure that the gutters, pipework and water tank leafstrainer are clean and free from debris.

• Once a year or when the water level falls below the main tap, remove the 25mm black drain bung at the base of the water tank and allow it to drain completely. If any sediment remains in the bottom of the tank, it can be hosed out with tap water.

• These simple steps will ensure a continuing supply of Clean Fresh Rainwater.
Also see:

Our Urban Range of Tanks

Installation Information

Our Range and their Dimensions

Fittings and Accessories